Bacharach Fyrite INTECH Configuration And Operation Manual

Also see for Fyrite INTECH: Quick start guide Configuration and operation manual

Bacharach Fyrite INTECH Configuration And Operation Manual Manual pdf 19 page image

FyriteInTech Manual Setup0024-9486 Rev 2 13Section 2. Setup2.1. Connecting the Probe and ThermocoupleA rigid stainless steel probe with handle is connected to a flexible hose with anintegral water-trap/filter used to draw a gas sample into the analyzer from theroom, grilles, diffusers, and furnace flues.1. Inspect the flue-gas hose for cracks. If a hose is defective, replace theentire probe assembly.2. Before using the analyzer, check that the water trap/filter is clean and dry.If necessary, dry out the trap and replace the filter element.3. Push the probe’s “sample gas” tubing onto the GAS inlet connector.4. Push the probe’s thermocouple into the T-STACK connector on theinstrument noting the orientation.IMPORTANT: The T-STACK connector tabs are keyed to fit into theconnector in only one orientation. DO NOT force thethermocouple connector tabs into the T-STACK connector.