Bacharach Fyrite Tech 50 Operating And Maintenance Instructions Manual

Also see for Fyrite Tech 50: Instructions Product catalog Quick start guide Instruction, Operation & Maintenance

Bacharach Fyrite Tech 50 Operating And Maintenance Instructions Manual Manual pdf 11 page image

Instruction 0024-9435 5Fyrite Tech3.0 SETTING UP THE ANALYZER3.1 ScopeBefore using the analyzer. . .• Check batteries (Section 3.2)• Connect probe to analyzer (Section 3.3)• Check setup (Section 3.5)3.2 Checking & Replacing the BatteriesInstall fresh batteries as described below. Check the analyzer for sufficientcharge prior to each use. Replace the batteries if the low-battery symbolappears in the lower right corner of the screen. To replace the bat-teries:1. Remove battery cover from back of analyzer.2. If old batteries are installed, remove them and properly discard.3. Observing the polarity markings inside the battery compartment,install four ‘AA’ Alkaline batter ies as shown in Figure 3-1.4. Replace battery cover.Figure 3-1. Battery InstallationRemove battery cover bypushing down on coverand sliding it outward