Bacharach MZ-RD Installation & Operation Manual

Bacharach MZ-RD Installation & Operation Manual Manual pdf 36 page image

MZ-RD – Multi-Zone Remote Display30 Instruction 3015-51574.8.4. Non Critical Faults• BOX TEMP FAULT – Enclosure’s internal temperature is outside normal range (or IR sensor hasfailed). Check the installation to verify that the monitor is not being subjected to extremetemperatures. Verify that the ventilation holes are not obstructed. Check the DiagnosticScreen for the ZERO temperature, BNCH temperature and BOX temperature. Call thefactory with this information for further instructions.• BENCH TEMP FAULT – IR sensor is outside of normal operating range (or sensor has failed).Check the installation to verify that the monitor is not being subjected to extremetemperatures. Check the Diagnostic Screen for the ZERO temperature, BNCH temperatureand BOX temperature. Call the factory with this information for further instructions.• PRESSURE SENSOR – Manifold pressure is outside normal operating range (or sensor hasfailed). Check the Diagnostic Screen record ALL data. Call the factory with this informationfor further instructions.• LOOP FAULT – This would only be displayed if the dual 4-20 mAdc option was installed andone or both current loops are open. Check the wiring to load/monitoring circuit on both 4-20 mA loops.• CONFIG FAULT – There is an error in Monitor Setup Screen #2 – Number Zones Installedfield, or in MZ-RD Setup Screen #1 – Number of monitors on Network field. Check that thenumber of zones installed for each unit and the number of units on the network are properlyprogrammed. Check to ensure that the manifold solenoid cable connector in each unit issecurely fastened to its terminal connector. Check for an illegal parameter. If necessary, resetto the factory default settings.4.8.5. Reset to Factory Default SettingsIMPORTANT: Performing this function deletes all program parameters, alarms, faults,trends and log files.Resetting a Multi-Zone1. Press and hold down the UP and DOWN arrow keys on the MZ monitor.2. Cycle AC power OFF then ON.3. Hold the keys until the second beep is heard.4. The screen will indicate “This unit has been reset to factory default conditions”.5. Release the keys.6. Reprogram the MZ as described in this manual.