Bacharach Monoxor III Operating & Maintenance Instructions

Also see for Monoxor III: Operation & maintenance Product catalog Specification sheet

Bacharach Monoxor III Operating & Maintenance Instructions Manual pdf 9 page image

Instruction 0019-9326 5Monoxor III3.0 PREPARING THE ANALYZERFOR OPERATIONTo prepare a new analyzer for operation, you must install four ‘AA’Alkaline batteries, install the probe (if needed), and set the correct timeand date as described in the following paragraphs.For your convenience, and to ensure that the analyzer will provide reliableCO readings, the CO sensor was installed and the analyzer calibrated on500 ppm CO at the factory.3.1 Battery InstallationInstall fresh batteries as described below. Check the analyzer for sufficientcharge prior to each use. Replace the batteries if the low-battery symbolappears in the lower right corner of the LCD. To install batteries:1. Remove battery cover from back of unit (see Figure 3-1).2. If old batteries are installed, remove and properly dispose of thebatteries.3. Observing the polarity markings inside the battery compartment,install four ‘AA’ Alkaline batteries.4. Replace battery cover.Figure 3-1. Battery InstallationRemove battery coverby pressing here andsliding cover outward