Bachmann Branchline Class 03 Owner's Manual

Bachmann Branchline Class 03 Owner's Manual Manual pdf 1 page image

Class 03 Diesel ShunterOwner’s InformationMany thanks for purchasing one of our Bachmann Branchline Class 03 Diesel Shunter Locomotives. A lot of carewas taken producing your model and we hope you enjoy it for many years to come.Although our models are highlydetailed and ready to run straightfrom the box we also supplyoptional accessories to be fitted bythe owner if they wish.Welcome1. AccessoriesPlease note: This model has been designed to run on curves of no less than 2nd Radius (438mm). We recommendthat you don’t use anything smaller as this may result in the model derailing.fig.1E3136 Instruction SheetBuffer Beam Plate (Fig.1)Remove the Standard Couplingfrom its mount and push fit theBuffer Beam Plate into place.There’s a corresponding part forthe cab end of the locomotive too.It is necessary that this Locomotive is ‘run-in’ to allow the mechanism and gears to settle. This requires the modelto be run without a load (wagons, coaches, etc.) for 30 minutes in each direction at half speed.2. Running-inAll Bachmann Branchline Locomotives are supplied ready lubricated and can be used straight from the box.Over time your locomotive will require some additional lubrication, when will depend on the frequency of useand storage, so please inspect your model on a regular basis.All moving parts of the connecting rods will occasionally need oiling. Apply a single drop of oil to the areasindicated in pink below (fig.2) and to the corresponding points on the other side.3. LubricationPlease note: A plastic compatiblelubricant is required. Suitableproducts from both the BachmannTrains & Woodland Scenics rangesare available from your localBachmann retailer.fig.2

/ 3

Related manuals for Bachmann Branchline Class 03