Bachmann LI1000 Manual
           | |
700.0000_User_Manual_REV02_EN created by BWS PM 10• The battery is separate fromother devices or chargers.• The battery is in an electricallynon-conductive package.• The battery is not stored outsidethe permissible temperaturerange of 0°C to 50°C.12. TransportationThe battery underlies the requirements fortransporting dangerous goods. The battery isclassified as UN 3480 (lithium-ion batteries)and has been tested in accordance with theUN Manual for Tests and Criteria, Part III,subsection 38.3. Read the document carefullybefore shipping the battery. Pull the battery out of the dockingstation. Ensure that the battery is in a safecondition Pack the battery in such a way thatthe following conditions are met:• The packaging is notelectrically conductive• The battery cannot movein the packaging Secure the packaging so that itcannot move13. Cleaning Switch off the battery Clean the battery with a dry cloth14. Maintenance andrepair Do not service or repair the batteryyourself If the battery needs servicing orrepair: Contact BACHMANNCustomer Service.15. DisposalDo not dispose of the battery in normaldomestic waste. Return the battery toBACHMANN GmbH for correct disposal. Contact BACHMANN CustomerService and request a return. BACHMANN GmbH will send younon-conductive transport packagingfor return, as an alternative you canalso return the battery in its originalpackaging. Before sending, make sure that thebattery is completely discharged andswitched off.16. Error handlingThe battery has a red LED, which lights up thepush button in the event of an error. Theoutputs of the battery are deactivated. Thefollowing table lists possible errors and theirpossible solution approach.Error Solution approachBattery cannotbe switchedon/off.Possibly the electronicshave hung up. Please pressthe "Reset" button locatednear the carrying handle. Ifthe battery is switched on,make sure that allconnected devices havebeen switched off properlybefore pressing the "Reset"button.Battery cannotbe switchedon/off.The pushbutton lightsred when theswitch ispressed.The battery electronics hasdetected an error andprevents the release of thebattery voltage at theoutputs. Check thepermitted operatingconditions (temperature,output power, operatingvoltage of the connecteddevices).Battery cannotbe switchedonThe battery has dischargeddeeper than permitted. Anelectronic protection functionprevents the switching on toprevent further discharge.Connect the charger andpress the "Wake Up" button.The yellow LED on thecharger, which is nowpermanently lit, indicatesthat the battery is beingcharged. After some time,the yellow LED startsflashing. From this point on,the soft-load mode isterminated, and the batteryis loaded normally. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine