9Figure 3-2 Connection Diagram6. Power on, the LED indicator will light up.3.3 Install on Pole1. Tighten the screws at the bottom of the bracket，as shown in Figure 3-3.Figure 3-3 Install the Bracket2. Install the bracket on pole as shown as Figure 3-4.

Product Overview

Technical Specifications

SW Specification

Environment Specification

Installation Guide

Install on Pole

Install on Wall

Regulatory Compliance

Configuration Guide

Basic Configuration

Set Scan Mode

Lock PCI

Appendix A FAQs

Bai cells EG7035E User Manual

EG7035E


Contents Table Of Contents Product Overview Technical Specifications SW Specification Environment Specification Installation Guide Install on Pole Install on Wall Regulatory Compliance Configuration Guide Basic Configuration Set Scan Mode Lock PCI Appendix A FAQs	9Figure 3-2 Connection Diagram6. Power on, the LED indicator will light up.3.3 Install on Pole1. Tighten the screws at the bottom of the bracket，as shown in Figure 3-3.Figure 3-3 Install the Bracket2. Install the bracket on pole as shown as Figure 3-4. Previous Next / 24