Baileigh Industrial ES-9138 Operator's Manual

Baileigh Industrial ES-9138 Operator's Manual Manual pdf 15 page image

1313 It is important to maintain free area around the machine, which is required for the workingplace. If any long material is machined, it is necessary to have a sufficient room in front ofthe machine as well behind it in the places of material input and output. LEVELING: The machine should be sited on a level, concrete floor. Provisions for securing itshould be in position prior to placing the machine. The accuracy of any machine depends onthe precise placement of it to the mounting surface. FLOOR: This tool distributes a large amount of weight over a small area. Make certain thatthe floor is capable of supporting the weight of the machine, work stock, and the operator.The floor should also be a level surface. If the unit wobbles or rocks once in place, be sure toeliminate by using shims. WORKING CLEARANCES: Take into consideration the size of the material to beprocessed. Make sure that you allow enough space for you to operate the machine freely. POWER SUPPLY PLACEMENT: The power supply should be located close enough to themachine so that the power cord is not in an area where it would cause a tripping hazard. Besure to observe all electrical codes if installing new circuits and/or outlets.Securing the BaseThis machine is typically a free standing unit. The machine should be sited on a level, concretefloor. Provisions for securing it should be in position prior to placing the machine. The accuracyof any machine depends on the precise placement of it to the mounting surface.1. Four rubber pads are furnished with the machine, which are to be placed under the machineat the four corners.2. Adjust the leveling pads as required for leveling.WARNING: Before operating; make sure this machine is firmlypositioned on all four feet. DO not allow the machine to tip or rock on the floor. If ittips over on you, it could cause severe injury or death.