Baileigh JP-1898-NC Operator's Manual

Baileigh JP-1898-NC Operator's Manual Manual pdf 22 page image

2020 Check with a qualified electrician or service personnel if the grounding instructions are notcompletely understood, or if in doubt as to whether the tool is properly grounded. Use only 3-wire extension cords that have grounding type plugs and receptacles that acceptthe tool’s plug. Repair or replace damaged or worn cord immediately.Extension Cord SafetyExtension cord should be in good condition and meet the minimum wire gauge requirementslisted below:LENGTHAMP RATING 25ft 50ft 100ft0-6 16 16 167-10 16 16 1411-12 16 16 1413-16 14 12 1217-20 12 12 1021-30 10 10 NoWIRE GAUGEAn undersized cord decreases line voltage, causing loss of power and overheating. All cordsshould use a ground wire and plug pin. Replace any damaged cords immediately.TECHNICAL SUPPORTOur technical support department can be reached at 920.684.4990, and asking for the supportdesk for purchased machines. Tech Support handles questions on machine setup, schematics,warranty issues, and individual parts needs: (other than die sets and blades).For specific application needs or future machine purchases contact the Sales Department at:sales@baileighindustrial.com, Phone: 920.684.4990, or Fax: 920.684.3944.Note: The manual cover photo illustrates the current production model. All otherillustrations are representative only and may not depict the actual color, labeling or accessoriesand may be intended to illustrate technique only.Note: The specifications and dimensions presented here are subject to changewithout prior notice due to improvements of our products.