Bajaj Pulsar 150 CC DTS-i User Manual

Also see for Pulsar 150 CC DTS-i: User manual

Contents

Bajaj Pulsar 150 CC DTS-i User Manual Manual pdf 12 page image

Before riding the motorcycle be sure to checkthe following items. Please give properimportance to these checks and perform all ofthem before riding the motorcycle. If anyirregularities are found during these checks,refer to the Maintenance chapter and seeAuthorised Dealer / Service center for theaction required to return the motorcycle to asafe operating condition.WARNING : Failure to perform thesechecks every day before you ride mayresult in serious damage or severeaccident.What to check Check forFuel Enough fuel for the planned distance ofoperation, no leaks in the fuel lines.Engine Oil Oil level between upper & lower marks.Throttle 1. Correct play in the throttle cable (2 to3 mm)2. Smooth operation & positive returnof throttle grip to the closed position.What to check Check forSteering Lock Correct operation.Brakes 1. Correct pedal play (25~30 mm).2. Brake lining wear indicator within‘USABLE RANGE’.3. No dragging.Drive chain 1. Proper slack (25~35 mm).2. Adequate lubrication.Lighting Operation of all lights.Horn Correct functions.Steering 1. Smoothness.2. No restriction of movement.3. Not Loose / Tight.Clutch 1. Correct lever play. (2 to 3 mm).2. Smooth operation of lever.Side and Return to their fully up position.Center StandTyres 1. Correct pressure.2. Adequate tread depth.3. No cracks or cuts.Mirrors Correct position.Daily Safety Checks20General Maintenance Information19Rainy Season Care :• It is suggested to customer to takeappropriate care in area of high rainfallarea. The appropriate surface preventivecoat to avoid rusting/poor surface finish onaccount of adverse atmospheric conditions.• Vehicle cleaning to be done with soft &clean wet cloth to avoid scratches onpainted parts.• Clean & lubricate all the important parts asdetailed in a periodic maintenance chart.• Do not apply direct water jet on painted,electrical / electronic parts.• Do not obstruct engine cooling by addingmud protection sheet from front.Front Brake Fluid Level• Front brake fluid master cylinder reservoir islocated near RH switch on handle bar.• To check oil level, keep the vehicle on Centerstand with handle bar in straight aheadposition.• Always ensure that brake fluid level is above‘MIN’ mark given on inspection window.• Use only DOT 3 or DOT 4 or equivalent brakefluid (from sealed container) to top up if reqd.It is advisable that brake fluid should bereplenished at every 30,000 Km or once in twoyears whichever occurs earlier.