3. How to operateOnce the bowl has been cleaned, fill the tank with the desired product (4.51, 1.2gallons).Do not overfill the tank. Note that when filling, shush occupies more volume than the liquid(approximately 1 gallon of slush). Be sure to consider product ratio (not exceeding 1 gallons totalmix for slush) before mixing or pouring product into tank. In order to keep your machine in goodworking condition, keep your machine full.If using natural products as a base (coffee, lemon juice, orange juice, etc.), it is required that 5 to7 oz. of sugar per gallon be added. Follow the dilution instructions on the bottle. In general themix ratio of the product shouldn't be less than 12.To Start the agitator, press main power and agitator switches to on position,Figure 8. Note: Depending on the version of your machine, the control panel maylook differently then figure 8, please also refer to switch symbols. Note that yourmachine is equipped with a time delay relay that provides for a three minute delayfrom the time of the initial start. This is to prevent the compressor from shortcycling.1. For liquid, press the cooler switch to bottom position. For slush, press the coolerswitch to up position.Note:The switch is a three position switch and order to have the machine off, the switch needsto be in the middle position.2. If machine is being used as a liquid cooler, the switch at liquid position, up, isprovided with an inside thermostat for controlling the liquid temperature.To illuminate the transparency on top of the unit and the product in the bowl press the display lightswitch to up position.Figure 8