Baker Hughes Masoneilan SVi 1000 Instruction Manual

Also see for Masoneilan SVi 1000: Instruction manual Quick start guide

Contents

Baker Hughes Masoneilan SVi 1000 Instruction Manual Manual pdf 55 page image

Masoneilan SVi1000 Positioner Instruction Manual =| 55© 2017 Baker Hughes, a GE company, LLC. All rights reserved.Auto TuneAuto Tune takes three to ten minutes and strokes the valve in large and small steps to set thePID positioning parameters for best response to an input signal change.This procedure overrides any previous configuration done using presets.To auto tune the SVi1000:1. Set the Configuration Selector Switch to the auto tuning parameter (Figure 29): 0 for an ATO valve (Air to Open application) 8 for an ATC valve (Air to Close application).Figure 29 Configuration Selection Switch2. Press the Autotune button until green LED 3 lights, then release (approximately 2 to 7seconds). The unit goes into a Commission Process and green LED 3 blinks.When the autotune process is complete the unit automatically returns to Normal mode.Press Cancel to abort the process and the green LED 3 goes off, the device returns toNormal mode and no changes to the tuning parameters occur.ConfigurationSwitchAutotuneButton andLED 3Button and LED 4CancelSelection