Bakers Pride EP-2-2828 Installation And Operating Instructions Manual

Also see for EP-2-2828 Single: Specifications Installation and operating instructions Parts list Parts list Specification

Contents

Bakers Pride EP-2-2828 Installation And Operating Instructions Manual Manual pdf 6 page image

3. ELECTRICAL CONNECTIONS1 Installation must be performed by a licensed electrician.2 A separate electrical connection to the mains must be provided for each oven.3 An all pole disconnect must be provided by the installer.4 Connection to the electrical service must be grounded in accordance with local codes. In theabsence of local codes refer to the National Electric Code, ANSI/NFPA 70 or the Canadian ElectricCode, CSAC22.2 as applicable.5 Only bare copper conductors with a minimum insulation temperature rating of 90ºC to be used.6 The installer must supply a properly sized strain relief bushing for the mains connection that meetsall codes.7 The oven shall be installed using flexible conduit.8 The restraint cord must be securely attached to the rear of the oven and to the building structure toprevent transmitting unnecessary stress to the flexible conduit.A wiring diagram is affixed to the inner side cover of the oven and included in the rear of this booklet.The input connection is accessed be removing the right side cover. Field connections are located at thelower rear corner of the control compartment.! !WARNING: Risk of electrical shock. Appliance must be secured to building structure.Double StackedOvensYour EP-2-2828 may bestacked two ovens on top ofone another. In order toinsure the ovens to not slideor separate, there is astacking bracket kit requiredfor installation at the rear ofthe ovens. Two bracketsare installed, one at eachend of the oven securing theupper oven to the bottomoven. Refer to the adjacentillustration.STACKING#10 SHEET METALSCREW (8)C5057X BRACKET (2)6! !Caution: Disconnect all ovens from electrical supply before servicing.