Baldor 15P Series Installation And Operating Manual

Also see for 15P Series: Installation and operating manual

Baldor 15P Series Installation And Operating Manual Manual pdf 18 page image

Section 4Setup and Operation4-1 Setup and Operation MN715POverview The operator interface panel is shown in Figure 4-1.Figure 4-1 Operator InterfaceJ4 Control Terminal StripJ5 Power Terminal StripPowerGND MotorGNDL1 L2 L3 T1 T2 T3B−R2 R11P1 P2 P3 P4 P5 P6S1DIP Switch(All OFF =factory settings)POWER FAULTFWDREVSTOP010203040 50 60708090100% SpeedPotentiometersP1 - P6POWERLED is on when AC input power is applied to the control.FAULTLED is on when a fault condition is present in the control.FWDPress FWD to initiate forward rotation of the motor, in local command mode.LED is on when control is in forward run mode.REVPress REV to initiate reverse rotation of the motor, in local command mode.LED is on when control is in reverse run mode.STOPPress STOP to initiate a stop sequence, in local or remote modes. Dependingon the setting of potentiometer P2, the motor will either ramp or coast to astop. The LED is on when the control is in stop mode.