Balluff SMARTCAMERA IO User Manual

Contents

Balluff SMARTCAMERA IO User Manual Manual pdf 21 page image

www.balluff.com214 First StepsBVS SC-_1280Z00-07-0_0SMARTCAMERA IOenglishThree simple steps are required to initially start up and configure the SMARTCAMERA. Besidesthe SMARTCAMERA, the following is required:– Power cable– 24 V power supply– LAN cable– PC with web browser1212PowerLANFigure 18: Establishing a network connection with the SMARTCAMERAConnect the SMARTCAMERA via the LAN port with the network.Depending on the network topology between computer and SMARTCAMERA, different networksettings must be made on the computer.In general, the network configuration of your computer is set to "Obtain an IP address automati-cally". For the firewall setting, Port 80 should be enabled.The following network structures are possible:– SMARTCAMERA and PC are connected directly via a LAN cableIP addresses are set automatically– SMARTCAMERA and PC are in the same subnet of a local network and a DHCPserver is available for automatic IP assignmentIP addresses are set automatically– SMARTCAMERA and PC are in the same subnet of a local network and no DHCPserver is available for automatic IP assignmentIn this case, the IP addresses of PC and SMARTCAMERA must be matched and manuallyset. Pertinent useful notes are located in the section “Network Settings / LAN Interface” onpage 25.– SMARTCAMERA and PC are in different subnets of a local networkSubnets are explicitly created to be able to subdivide computers in different networks and tostructure it in this way. Since the different subnets, on the other hand, are connected viaswitches, the communication with the SMARTCAMERA is still possible. Pertinent usefulnotes are located in the section “Network Settings / LAN Interface” on page 25.Now connect the power supply at the Power port with the power supply (24 V).The SMARTCAMERA starts up and is operational after approx. 30 seconds.At the start, the SMARTCAMERA opens the most recently opened inspection program and is inthe same process state it occupied at switch-off.4.1 Step 1:Establishing anetwork con-nection withthe SMART-CAMERA4.2 Step 2:Switching onthe SMART-CAMERA