Band-it Ultra-Lok UL9010 Operating Instructions Manual

Also see for Ultra-Lok UL9010: Clamping Instructions Clamping Instructions

Contents

Band-it Ultra-Lok UL9010 Operating Instructions Manual Manual pdf 7 page image

BAND-IT-IDEX, Inc.A Unit of IDEX Corporation4799 Dahlia StreetDenver, CO 80216-0307 USAPh: 1-800-525-0758Fax: 1-800-624-3925Document # P44987 Rev. N© CopyrightBAND-IT-IDEX, Inc. 2011All rights reservedwww.BAND-IT-IDEX.comPage 7 of 14UL9010Ultra-Lok ToolTroubleshooting192261829302 Places4 Places4 Places23 4 Places4 Places28202 PlacesSee page 6 for parts listTroubleshooting1. Lock slips down in buckle: Verify tightness of blade mounting screws. If lock on clamp is still not adequate,reduce tension on tool by setting torque control knob to a lower number or reduce speed of the drill. (See “Setting upproper tension”)2. Drill makes loud, rapid clicking noise: Make sure hammer drill setting is off and indicator is pointing to drillsymbol. (Hammer symbol on selector knob pointing to back).3. Drill makes whining noise when clamp gets tight: The drill is equipped with its own internal safety clutch. If thisclutch disengages usually above torque setting 6, reduce torque setting and lubricate tension screw. Do not confusethis clutch with the coupling between drill and tool.4. Safety clutch between drill and tool releases prematurely: Make sure tool is fully seated on drill and safetyclutch is fully engaged with tip of tension screw. (Loosen clamping screw and re-tighten while pressing tool into drill).See page 4, if problem still remains, replace tension screw (BAND-IT # M00987).Note: To prevent safety clutch wear, do not over-use. When tensioning clamp, let drill switch go as tension blocknears its end of travel. Reverse drill and send tension block all the way forward for a second pull on the band.5. If tool does not cut off on initial setting:Step 1: Pull trigger of tool after engaging cutter blade.Step 2: Increase torque setting slightly, and repeat tensioning band and engaging of cutter blade.Step 3: Repeat steps 1 and 2 until band cuts.46Tension BlockASSYTension BlockASSYSee page 6 for parts listHead Unit