7ConnectionsThe Beolab Penta can beconnected to either a receiver, aTV set, a Master Control Link 2 Aor a Master Control Link 2 AV(MCL 2 A/2 AV).For lengths and parts numbersof the cables which can be used,see the section “Optional acces-sories”.NOTE! Before connecting theBeolab Penta to the receiver, TVset or MCL 2 A/2 AV, make surethat the MODE switch on thefront panel is set to OFF. Thisprecaution applies to both theinitial set-up and to later rearran-gements of connections.Do not switch on your audio orvideo system until you have set theswitches on the front panel to theircorrect position (see pp 11-13).Connection to a Bang & Olufsen receiver or TV set or an MCL 2 A/2 AVWhen connecting your BeolabPenta, you may use either thePOWER LINK socket or theSPEAKER LINK socket.POWER LINK 1 & POWER LINK 2sockets(using an 8-pin DIN Power Linkcable).The sockets marked POWERLINK 1 & 2 are identical. Thismeans that either socket can beused when you connect yourBeolab Penta by means of aPower Link cable.Plug one end of the cable intoone of the POWER LINK socketson the Beolab Penta.Plug the other end of the cableinto one of the POWER LINKsockets on your receiver, TV setor MCL 2 AV.Repeat the procedure for theother speaker.POWER LINK 1 POWER LINK 2