Bang & Olufsen BeoVision Avant 32 DVD MKII Repair Manual

Also see for BeoVision Avant 32 DVD MKII: Repair guide

Contents

Bang & Olufsen BeoVision Avant 32 DVD MKII Repair Manual Manual pdf 130 page image

Dismantling, English 6.1DISMANTLINGIllustrations are placed on page 6.21 – 6.22.Contrast screen, removalRemove the screws below the picture tube. See ➢10. Use one hand to pushupwards just below the Bang & Olufsen logo, and at the same time use the otherhand to carefully pull outwards at the top. Carefully remove the contrast screen.Contrast screen, mountingPlace the contrast screen in the metal brackets in the bottom corners of the frontframe. See ➢11. Grib the side edges of the screen with both hands and pushinwards.Please note that it must be easy to push it into place. If not the contrast screenmay not be properly mounted in the metal brackets. The contrast screen mightshatter if being forced into place.Push the contrast screen into place at the top, and gently push it down. Mountthe screws below the picture tube. See ➢10.For cleaning use a mild window cleaning fl uid. Make sure no streaks or traces areleft on the screen or picture tube. Make sure that no moisture is left between thecontrast screen and the front frame.Mains Distribution, PCB60 (with mains voltage fuse)Remove the bottom section of the rear panel by loosening four screws. The blackplastic box containing PCB60 can now be opened. See ➢12.Cloth frontInsert a screwdriver at the center just below the cloth front (K) and wriggle up thecloth front without damaging strip or cloth front. Push the cloth front to the right,about one cm. Then pull out the cloth front carefully. See ➢10.For mounting of the cloth front, hold it straight onto the TV, placing it just a littleto the right. Make sure the clips fit into the holes in the TV. Then carefully push itto the left to make it fi t on the TV. It is easily felt if it has been misplaced.Speaker cabinetsRemove the upper rear panel (6 screws). Remove the lower rear panel (4 screws).Remove the speaker front fabric. Remove the screw at the top of the speaker cabinet,as viewed from the front. The speaker cabinet can now be pulled backwards.When installing the speaker cabinet, the two rubber dampers must be fitted onthe towers at the bottom of the speaker cabinet, and they must be fitted into theholes in the bottom of the main frame.Motorized standCarefully place the BeoVision Avant 32 DVD on its side.Remove the 4 pieces of tape covering the holes in the bottom of the motorizedstand. Turn the motorized stand until the 4 holes in the bottom are aligned withthe screws. Unscrew the 4 screws to remove the motorized stand.The aluminium sheet on the motorized stand is fixed with double-sided adhesivetape.STATIC ELECTRICITYMAY DESTROY THEPRODUCTABO-CENTER v/HENRIKSENS ELEKTRONIK