Banner American BA-FS27 Operating Instructions Manual

Contents

Banner American BA-FS27 Operating Instructions Manual Manual pdf 11 page image

CAUTION: Heated Rollers are for warm-up onlyand should be turned off when operating temp-erature is reached to avoid damaging the rollers.4. Set the temperatures according to the film manufacturer’s recommendations for the film you have chosen.The Finisher 2700 will take approximately 15 minutes to reach operating temperature. The roller and shoetemperatures are indicated on the LCD displays on the control panel.5. Turn the fans ON. This allows for a clear lamination by cooling the film as it exits the rollers.6. Perform a test mount to ensure proper settings for successful mounting. If any adjustments are necessarymake them now and run another test. Repeat this step until you obtain desired results.7. Position the print to be mounted on a section of mount board up to ½” thick.8. Feed the print and mount board into the laminator behind the leader board slowly and evenly. If you areusing a low-tack mount board, be sure to pull back the release liner before it enters the rollers.9. You may mount subsequent prints now, one directly behind the other so that the board in front becomesthe leader board.10. Once your last print has completely exited the laminator, turn the MOTOR CONTROL and FAN switchesOFF and use the trimmer on the rear of the laminator to remove the mounted and laminated prints.X. Maintenance/Service...Always use caution when servicing your laminator.Precautions:Disconnect the power supply and open the panel breaker be-fore attempting to service or repair the laminator.Any maintenance or service should be performed only by thosehaving appropriate technical training and experience. Contactthe manufacturer at 800-572-2144 for training information ortechnical assistance.Adjust only those controls that are specified in these operat-ing instructions.Cleaning Rubber Rollers:Excessive build-up of adhesive on the rollers may cause poor lamination quality and erratic film movement.Use the following procedure to remove any adhesive from the laminating rollers.1. Turn the HEATED ROLLERS and TOP & BOTTOM HEAT switches OFF and allow the laminator tocool.2. Cut the film where it comes off the top and bottom supply rolls. Pull any film out of the laminator andaway from the heat shoes.3. Remove the feed table and RollerShoes™ to access the rollers.4. Disconnect the power supply.5. Clean the exposed section of the rollers with a soft cloth dampened with an appropriate cleaning solutionsuch as isopropyl or denatured alcohol.6. Reconnect the power supply and turn the FORWARD/REVERSE switch to the FORWARD position.9abcoffice 800-658-8788 www.abcoffice.com

/ 14

Related manuals for Banner American BA-FS27