Banner American Finisher 4300 Operating Instructions Manual

Also see for BA-FS43: Operating instructions Operation manual

Contents

Banner American Finisher 4300 Operating Instructions Manual Manual pdf 10 page image

Cleaning Rubber Rollers:Excessive build-up of adhesive on the rollers may cause poor lamination quality and erratic film movement.Use the following procedure to remove any adhesive from the laminating rollers.1. Turn the HEATED ROLLERS and TOP & BOTTOM SHOES OFF and allow the laminator to cool.2. Cut the film where it comes off the top and bottom supply rolls. Pull any film out of the laminator and awayfrom the heat shoes.3. Carefully remove the feed table and heat shoes to access the rollers. The feed table is heavy andremoving it exposes hot and moving parts.4. Disconnect the power supply.5. Clean the exposed section of the rollers with a soft cloth dampened with an appropriate cleaning solutionsuch as isopropyl or denatured alcohol.6. Reconnect the power supply and turn the FORWARD/REVERSE switch to the FORWARD position.Turn the MOTOR switch to the ON position momentarily to expose a new section of the rollers.7. Repeat steps 3-5 until the rollers are thoroughly clean.8. Allow the rollers to dry completely before rethreading the laminating film.Cleaning Heat Shoes:Clean the heat shoes periodically to avoid adhesive build-up. Build-up can inhibit the film from moving overthe shoes smoothly. Use the following procedure to clean the heat shoes.1. Turn the HEATED ROLLERS and TOP & BOTTOM SHOES OFF and allow the laminator to cool.2. Cut the film where it comes off the top and bottom supply rolls. Pull any film out of the laminator and awayfrom the heat shoes.3. Disconnect the power supply.4. Open the safety shield and carefully remove the feed table to expose the heat shoes. The feed table isheavy and removing it exposes hot and moving parts.5. Clean the heat shoes with a clean, soft cloth dampened with an appropriate cleaning solution such asisopropyl or denatured alcohol. Since the heat shoe is hard anodized you can use a scrub pad or very finesteel wool.6. Allow the heat shoes to dry completely before rethreading the laminating film.Removing Wrap-Arounds:Build-up on the rollers and heat shoes may cause a film wrap-around, especially when using thin film gauges.Follow the procedure below to remove wrap-arounds.1. Turn the HEATED ROLLERS and the TOP & BOTTOM SHOES OFF. Allow the laminator to cool.2. Cut the film where it comes off the top and bottom supply rolls.3. Open the ROLLER RELEASE handle onthe side of the laminator and pull the film out of the unit that hasbecome wrapped around the rollers.4. If you have a severe wrap-around, it may be necessary to use the REVERSE feature to back the filmout. Be sure to pull the film away from the laminator.8abcoffice 800-658-8788 www.abcoffice.com

/ 12

Related manuals for Banner American BA-FS43