Banner American Finisher 4300 Operation Manual
Also see for BA-FS43: Operating instructionsOperating instructions
            | |
X. Trouble-shooting...Symptom Possible Cause Corrective ActionLCDs do not show display No power to laminator Close panel breakerwhen heat switches are on.Blown fuse Disconnect power andreplace fuseFilm is not bonding to the print Laminator not set to optimal Adjust temperature slightlylaminating temperature upward.Ink on print is wet Allow ink to dry thoroughlyPaper is too slick Use a more matte paperLaminated item curls Top or bottom film tension Loosen tension on side (topis too high or bottom) that is curling upLaminated item is wrinkled Mandrel tension too loose Increase mandrel tension onside (top or bottom) that haswrinklesTemperature too high Reduce temperatureMoisture in paper being laminated Store paper in dry areaLaminated item is blistered Temperature too high Reduce temperatureMandrel tension does not remain Brake nut improperly adjusted Tighten nutconstantCore gripper blade is not preventing Rotate film core whileholding the mandrelthe core from spinning on the firm to lock themandrel blade into the core.Mandrels are reversed. Reverse mandrels91-800-543-5454 www.officezone.com |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine