Banner LS2e30-300Q8 Instruction Manual

Contents

Banner LS2e30-300Q8 Instruction Manual Manual pdf 20 page image

3.2 Mounting System Components3.2.1 Overview of Emitter/Receiver Mounting HardwareMounting HardwareThe EZ-SCREEN standard end-cap mounting brackethardware is supplied with each emitter and receiver.Brackets are designed to mount directly to MSA Seriesstands using the hardware with the supplied stands.Figure 10. Emitter and Receiver End-Cap Mounting BracketsUsing Center Mounting BracketsCenter mounting brackets are supplied with longer sensorsand must be used whenever the sensors are subject toshock or vibration. The sensors are designed to be mountedwith up to 450 mm (18 in) distance between brackets:• Sensors 600 to 900 mm (24 in to 36 in) long aresupplied with one center bracket, which should becentered on the sensor.• Sensors 1050 to 1350 mm (42 in to 54 in) long aresupplied with two center brackets, which should bepositioned 1/3 of the sensor's length from eachsensor end.• Sensors 1500 to 1800 mm (59 in to 71 in) long aresupplied with three center bracketsTo install each bracket:1. Spread the clamp and snap over the back of thesensor so that the clamp is securely fastened to thesensor without blocking any beams.2. Compress the foam spacer and slide the clampalong the length of the sensor housing to align theclamp with the center mounting bracket as shown inFigure 11 on page 20. Three separate mountingholes are provided on the clamp to allow for allpossible mounting configurations.3. Connect the clamp to the center bracket using theM3 screw supplied.4. Loosen all the mounting screws to the sensor, alignthe sensors and then tighten the end screws.Finally, tighten the M3 screw joining the clamp tothe center mounting bracket. Figure 11. Emitter and Receiver Center Mounting BracketsEZ-SCREEN® Type 2 Light ScreenPhone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com