Banner QS30LLPQ Manual

Also see for QS30LLP: Manual Quick start guide

Contents

Banner QS30LLPQ Manual Manual pdf 2 page image

Excess GainWith Supplied Target BRT-51X51BM With Supplied Target BRT-TVHG-2X2 With Target BRT-2X2 (Optional)1101001.0 m3.3'10 m33'100 m330'0.1 m0.33'1000EXCESSGAINDISTANCEwith BRT-51X51BM1101001.0 m3.3'10 m33'100 m330'0.1 m0.33'1000EXCESSGAINDISTANCEwith BRT-TVHG2X21101001.0 m3.3 ft10 m33 ft100 m330 ft0.1 m0.33 ft1000EXCESSGAINDISTANCEwith BRT-2X2OverviewQS30LLP and QS30LLPC Series sensors are easy-to-use, high-performance laser sensors whose many configuration options makethem suitable for demanding applications. Each sensor features two identically configured outputs, one each NPN and PNP.The compact housing has a large, easy-to-see bargraph display plus bright LEDs for easy configuration and status monitoring duringoperation. The sensor can be side-mounted, using integral mounting holes, or front-mounted, via the 30 mm threaded barrel.MODEL QS30LLP(Q) is configured using the Maximum Excess Gain SET procedure. It is useful for long-range applications and highvariations in contrast, such as beam-break applications where the target objects are larger than the beam. See Maximum Excess GainSET - Model QS30LLP on page 3 for more information.MODEL QS30LLPC(Q) is configured using the Low-Contrast SET procedure. It is useful for small object detection and other applicationswith small variations in contrast, such as yarn- or thread-break applications. See Low-Contrast SET - Model QS30LLPC on page 5 formore information.Yellow OutputConductingIndicatorGreen Power ONIndicatorConfigurationPushButtonsSwitchingThresholdBargraphDisplaySETUP StatusIndicators:DelayDark OperateLight OperateFigure 1. Model QS30LLP FeaturesYellow OutputConductingIndicatorGreen Power ONIndicatorConfigurationPushButtonsSwitchingThresholdBar GraphDisplaySETUP StatusIndicators:DelayDark OperateLight OperateFigure 2. Model QS30LLPC FeaturesSensor ConfigurationSensor configuration is accomplished using the SET and SETUP modes. After SET mode has defined the sensing parameters, SETUPmode may be used to add an OFF-delay or change the light/dark operate status. Manual Adjust may be used to fine-tune the thresholds.Two push buttons, “+” and “-”, may be used to access and set sensing parameters. In addition, the remote wire also may be used forsome procedures (see below).WORLD-BEAM QS30 LLP and LLPC2 www.bannerengineering.com - tel: 763-544-3164 P/N 112355 Rev. C