DatasheetConfigurable DX80 Gateway that uses DIP switches to map inputs from up to six Nodes (or Wireless Q45 Sensors) to theGateway's outputsDX80...C ModelDX80 ModelThe Sure Cross® wireless system is a radio frequency network with integrated I/O that operatesin most environments and eliminates the need for wiring runs. Systems are built around aGateway, which acts as the wireless network master device, and one or more Wireless Q45Sensors.• Wireless industrial I/O device with six discrete (sourcing) inputs and six discrete(sourcing) outputs• DIP switches allow the user to select one of eight defined I/O mapping configurations toautomatically map the Nodes' inputs to this Gateway's outputs• Frequency Hopping Spread Spectrum (FHSS) technology ensures reliable data deliverywithin the unlicensed Industrial, Scientific, and Medical (ISM) band• Transceivers provide bidirectional communication between the Gateway and Node,including fully acknowledged data transmission• Site Survey analyzes the network’s signal strength and reliability and displays the resultson the Gateway's LCD• LCD shows I/O status, Site Survey results, and network status information• Lost RF links are detected and relevant outputs set to user-defined conditionsFor additional information, updated documentation, and a list of accessories, refer to Banner Engineering's website,www.bannerengineering.com.WARNING:• Do not use this device for personnel protection• Using this device for personnel protection could result in serious injury or death.• This device does not include the self-checking redundant circuitry necessary to allow its use inpersonnel safety applications. A device failure or malfunction can cause either an energized (on) or de-energized (off) output condition.ModelsModel Frequency Environmental Rating I/ODX80G2M6-Q 2.4 GHz ISM Band IP67, NEMA 6 Inputs: Six sourcing discreteOutputs: Six sourcing discreteDX80G2M6-QC IP20, NEMA 1Configure and Install Your Q45 NetworkFollow these steps to set up and install your Wireless Q45 network.1. On the Wireless Q45 Sensor Node:a) Configure the DIP switches (if applicable).b) Apply power.2. On the Gateway or DXM:a) Configure the DIP switches (if applicable).b) Wire the I/O.c) Apply power.3. Bind the Q45 to the master radio.4. Observe the LED behavior to verify the devices are communicating to each other.5. Using the configuration software, configure the I/O mapping between the Q45 and its master radio.6. Conduct a Site Survey between the Gateway and the Wireless Q45.7. Install your devices.Configure the GatewaySure Cross® DX80 Gateway for Wireless Q45SensorsOriginal Document161862 Rev. E3 December 2020161862