Banner Sure Cross P2-KR Manual

Banner Sure Cross P2-KR Manual Manual pdf 1 page image

DatasheetThe Sure Cross® wireless system is a radio frequency network with integrated I/O that operates in most environments to eliminatethe need for wiring runs.• Wireless industrial I/O device with four selectable discrete inputs, four sourcing discretesourcing outputs, two universal analog inputs, and two 0 to 20 mA analog outputs• 10 to 30 V dc power input• DIP switches for user configuration• Modbus serial interface• Site Survey analyzes the network’s signal strength and reliability and displays the results onthe Gateway's LCD• Frequency Hopping Spread Spectrum (FHSS) technology ensures reliable data delivery withinthe unlicensed Industrial, Scientific, and Medical (ISM) band• Transceivers provide bidirectional communication between the Gateway and Node, includingfully acknowledged data transmission• Lost RF links are detected and relevant outputs set to user-defined conditionsFor additional information, updated documentation, and a list of accessories, refer to Banner Engineering's website,www.bannerengineering.com/wireless.WARNING:• Do not use this device for personnel protection• Using this device for personnel protection could result in serious injury or death.• This device does not include the self-checking redundant circuitry necessary to allow its use inpersonnel safety applications. A device failure or malfunction can cause either an energized (on) or de-energized (off) output condition.Important:• Electrostatic discharge (ESD) sensitive device• ESD can damage the device. Damage from inappropriate handling is not covered by warranty.• Use proper handling procedures to prevent ESD damage. Proper handling procedures include leavingdevices in their anti-static packaging until ready for use; wearing anti-static wrist straps; andassembling units on a grounded, static-dissipative surface.ModelsModels Frequency Environmental Rating I/ODX80G2M6S-P2-KR 2.4 GHz ISM Band IP67, NEMA 6 Inputs: Four selectable discrete, two 0 to 20 mA or 0 to 10 V analogOutputs: Four sourcing discrete, two 0 to 20 mA analogConfiguration InstructionsSetting Up Your Wireless NetworkTo set up and install your wireless network, follow these steps.Disconnect the power from your Sure Cross devices.1. Configure the DIP switches of all devices.2. If your device has I/O, connect the sensors to the Sure Cross devices. If your device does not have I/O, skip this step.3. Refer to the wiring diagrams to apply power to all devices.• For housed models, the Gateway's LED 1 is solid green and the Node's LED 2 flashes red to indicate there is no radiolink to the Gateway.• For board-level models, the Gateway's LED is solid green and the Node's LED flashes red to indicate there is no radiolink to the Gateway.4. Form the wireless network by binding the Nodes to the Gateway. If the binding instructions are not included in thedatasheet, refer to the product manual for binding instructions.Sure Cross® Performance P2-KR GatewayOriginal Document182821 Rev. B18 January 2019182821