Banner SureCross DX80 Gateway Network Manual

Contents

Banner SureCross DX80 Gateway Network Manual Manual pdf 10 page image

123451. Housing. The rugged, industrial DX80 housing meets IEC IP67standards.2. Mounting hold, #10/M5 clearance. Mounting Holes accept metricM5 or UNC/UNF #10 hardware -- DIN rail mount adapter bracket avail-able.3. Wiring terminal strip. The 16 spring-clip type wiring terminals acceptwire sizes: AWG 12-28 or 2.5 sq mm.4. Port, PG-7 gland or blank. The PG-7 threaded ports can accept pro-vided cable glands or blanks.5. Ribbon connector. Ribbon cable connects wiring base to LCD/radio.The GatewayPro has no serviceable parts inside the housing and no wiring chamber. During setup or standard operation, there shouldnot be a need to open the GatewayPro.DX80 GatewayProThe GatewayPro has many of the same features as the Gateway and Node, including the LEDs, the buttons, LCD, and Euro-style con-nector.1 Industrial ethernet port, female.2 Rotary switch 1 (left). Sets the Network ID (NID) to a hexidecimal valuefrom 0 to F, for a total of 16 Network IDs. A Gateway and its correspondingNodes must be assigned the same Network ID.Rotary switch 2 (right). On the Gateway, sets the Gateway’s LCD viewingdevice address. The Gateway is predefined as Device Address 0. On theNode, sets the Node’s Device Address (hexidecimal 1 to F). Each Nodewithin a network must have a unique Node Device Address.3 Push button 1. Single-click to advance across all top-level DX80 menus.Single-click to move down interactive menus, once a top-level menu ischosen.4 Push button 2. Double-click to select a menu and to enter manual scrollingmode. Double-click to move up one level at a time.5 LED 1 and 2. Provide real-time feedback to the user regarding RF link sta-tus, serial communications activity, and the error state.6 LCD Display. Six-character display provides run mode user informationand shows enabled I/O point status. This display allows the user to con-duct a Site Survey (RSSI) and modify other DX80 configuration parame-ters without the use of a PC or other external software interfaces. On theNode, after 15 minutes of inactivity, the LCD goes blank. Press any buttonto refresh the display.7 5-pin M12 Euro-style quick disconnect serial port.DX83 Ethernet BridgeThe DX83 Ethernet Bridge uses the same housing and same mounting holes as the Gateway and Node.SureCross Wireless I/O Network Manual10 www.bannerengineering.com - tel: 763-544-3164 rev. I