Banyo Flamerite Apollo Manual
    | |
Page 2 of 4Fig.1 Fig.2 Fig.3 Fig.4 Fig.5Log Fuel Effect LayoutThe stove is supplied with a 1 piece flat orange fuel bed, a 1 piece moulded log effect fuel bed and 5 clay-moulded logs.Place the flat orange fuel bed into the recess above the light bulbs, followed by the 1 piece moulded log effect fuel bedagainst the back of the chamber.The log formation is subjective to the end user but we recommend following the image in Fig.6 to give the most authenticyet random look. Please spend time adjusting to suit.Fig.6PebblePlace the pebbles onto the semicircular orange base. Start with the larger pebbles around the outside and the smaller on the insideand stacked on top.Fitting the Glass Front & TopUnpack the front, top and 2 fixing pins. Place the front onto the stove at 45 degrees bottom channel first. Straighten thefront 90-degrees and align the holes with those at the top of the stove. Drop in the two pins provided to secure.Gently place the top onto the stove. The guilds on the underside of the top will slot/sink into and around the perimeter ofthe stove.Fitting (Optional) Stove Flue PipeQuite simply place the flue pipe into the recess in the glass top.Electrical ConnectionsYour appliance comes fitted with a plug that incorporates a 13A fuse. The replacement fuses must be 13A and ASTA approved. If thefuse cover is lost the plug must not be used until a replacement cover, of the same colour, is obtained from an electrical retailer.The appliance is fitted with a moulded plug if it is necessary cut off the plug, for any reason, it must be discarded immediatelywith the fuse removed. Under no circumstances should any attempt be made to reuse the plug, do not insert into any 13Asocket as this could cause a hazard. If the mains cable is damaged it must be replaced by the manufacturer or an authorisedtechnical service centre.WARNING THIS APPLIANCE MUST BE EARTHEDIMPORTANTThe wires in the mains lead are coloured in accordance with the following code.Green and yellow: EARTHBlue: NEUTRALRed: LIVEAs the colours of the wires in the mains lead of this appliance may not correspond with the colour markings in your plug proceed asfollows: - |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine