Baotian BT49QT-7 Service Manual

Also see for BT49QT-7: User manual

Contents

Baotian BT49QT-7 Service Manual Manual pdf 13 page image

11II. PRECAUTIONS IN OPERATIONRemoved washers, 0-rings, elastic retaining rings and split pins must be replaced with newones.When mounting bolts, nuts and screws, proceed from trial tightening, from largerdiameters to smaller diameters and inner ones to outer ones in a diagonally order. Tightenthem to specific torques.Parts and greases must be those made by our factory or recommended by our factory.Special operations must be effected with special tools or specified universal tools.Removed parts must be rubbed or cleaned before they are inspected or measured. Theymust be coated on the sliding faces before mounting.They must be greased at the specified positions with designated or equivalent greases.Parts must be tightened and their performances inspected at their positions when mounted.The battery’s negative terminal must be disconnected before operation.Make sure that tools such as wrenches are not in contact with the frame.At the completion of operations, reconfirm correct connections and fastenings.The positive terminal must be connected first in case of a removed battery.Connected terminals must be coated with lubricant.The terminals must be completely covered with caps.When a fuse is burnt, inspect the cause and replace the fuse with a fuse of equivalentcapacity.At the completion of operation, completely cover terminals with caps.When removing connectors with locks, they must be unlocked before operation.When removing connectors, the connectors proper must be held instead of pulling theirwires.Before connecting connectors, confirm that they are free from breakage, bending, overlength or loosening.Connectors must be inserted home.When connecting connectors with locks, confirm that their locks are fastened.Confirm that the wires are not loose.Confirm that connectors’ plastic sleeves completely cover the connectors without fail.Before connecting the connectors, confirm that their sleeves are free from breakage andtheir terminals are not oversized.Connector plugs must be fully inserted.Confirm that plastic sleeves completely cover the terminals.Plastic sleeves should not be placed with the open side up.Wire bunch bands should be fixed at the specified position of motorcycle frame.Wire clamps must correctly keep wires in place.Avoid welding stains of welded clamps when clamping wires.