Barbeques Galore Y0662LP Owner's Manual

Contents

Barbeques Galore Y0662LP Owner's Manual Manual pdf 12 page image

Assembly Instructions1. Unscrew Igniter Cap(s) located on the grill ControlPanel and remove the Contact(s) and Spring(s) fromthe Battery Holder(s).2. Place an “AA” battery into Battery Holder(s). Be sureto place the positive pole facing toward you. SeeFigure 13.3. Place the Spring over the AA battery, then place theContact on top of the Spring. Screw Igniter Cap(s)back onto the grill Control Panel.Electrode Check - Requires an AssistantBefore placing the cooking components into your grill,ensure that the Spark Electrode Tips are properly positionedwithin each Gas Collector Box (a 3-1/4” wide stainless mech-anism found at the front between each set of burners.) Theeasiest way to ensure this is to perform this Electrode Check:1. Be sure all Control Knobs are set to ”OFF”. Open the GrillLid.2. Have an assistant stand behind to the right of the grill andlook down at the Gas Collector Box of the main burners.NEVER put your face inside Grill Head.3. Press center Igniter Cap and have assistant watch for asmall blue spark within each Gas Collector Box. if a sparkis present the Electrode Tips are properly positioned.4. If no spark is seen, the Spark Gap shown in Figure 14needs to be adjusted as follows:! Using an adjustable wrench, loosen the Inside Nut justuntil the Gas Collector Box can be maneuvered andturned upward.! The gap between the Spark Electrode Tip and Sparkreceiver should be approximately 3/16”.! if the gap is wider than 3/16” use a pair of long nose pli-ers and gently squeeze the Gas Collector Box until thegap is correct.! Return the Gas Collector Box to its original horizontalposition, secure the Inside Nut and try the ElectrodeCheck again.lnstalling Cooking ComponentsImportant: Before cooking on your grill for the first time,wash the cooking grids and warming rack with warm, soapywater. Rinse and dry thoroughly. Season with cooking oilregularly. After cooking is completed, turn grill to HIGH set-ting for about five minutes to burn off excess grease or foodresidue.1. Place the Ceramic Flame Tamers on the Ceramic Rackand place on the lower ledge above the burners.2. Evenly space the Stainless Steel Cooking Grids on theledge above the Flame Tamers.3. Place the Upper Warming Rack into the holes on theupper left and upper right of the back burner frame withthe bottom resting in the slots on either side of the grillbowl.BATTERY HOLDERAA BATTERYCONTACT SPRINGCONTACTIGNITERCAPFigure 13Figure 14 INSIDE NUTGAS COLLECTOR BOXSPARK ELECTRODE TIP3/16”SPARKGAPUPPERWARMING RACKCOOKINGGRIDCERAMICFLAME TAMERPOTSUPPORTFigure 15- 12 -CERAMICRACK