3. OVERVIEW USER’s CONTROLS3. OVERVIEW USER’S CONTROLSOverview• On Cine VERSUM Master• On Cine VERSUM 50• On Cine VERSUM 80• On InfraRed Remote Control3.1 On Cine VERSUM MasterFront ViewThe front side of theCine VERSUM Master is provided with the following controls:Image 3-1Front side Cine VERSUM MasterControls function descriptionRef. Function Description1 Infra Red Reception LED indicator Lights up when a valid IR signal from the Remote Control has beencaptured.2 Infra Red Receiver Infra Red reception diode for the IR signals from the IR transmitter3 Standby LED Blinks when the Cine VERSUM Master has been powered down toStandby or Economy Standby mode.4 Push button main power switch Button pressed, switches the Cine VERSUM Master in:• the ’powered up’ mode if the latest Master status was ’Operationmode’.• the ’standby’ mode if the latest Master status was ’standby’ or’Economy standby’ mode.5 Blue Dot Matrix display with white LEDbacklightingThis display indicates the status of the Cine VERSUM Master and alsothe items when navigating through the different menu’s.6 Start up and Random access adjustmentmode selection knobAll source parameters and picture tuning are setup in the adjustmentmode.Table 3-13.2 On Cine VERSUM 50Rear and Front viewThe only hardware control on the Cine VERSUM 50 is the Main Power Switch (1), located at the backside of the screen itself.This switch puts the Screen in the OFF or Standby position. From the Standby position, operation mode is controlled by the CineVERSUM Master.The status of the Plasma screen is indicated by a blue LED (3), located at the bottom on the right of the screen. In the same corneran IR LED (2) is mounted to allow controlling the Cine VERSUM system via the screen.R5976490 CINE VERSUM SYSTEM 06092002 9