10. Removal and installation of projector covers10. REMOVAL AND INSTALLATION OF PROJECTORCOVERSAbout this chapterMost maintenance and servicing procedures demand removing one or more of the projector covers to gain access to the parts tomaintain or to service. To avoid redundancy, all procedures about cover removing or installing are grouped together in this chapter.The maintenance and servicing procedures also refer to this chapter if required. The procedures in this chapter describe, withdetailed step by step actions and illustrations, how to remove or install the projector covers. Note that some covers may only beremoved by qualified service personnel, see remarks above each procedure.WARNING : Always switch off the projector and unplug the power cord before removing one of the covers,unless otherwise stated.Overview• Removal of the lamp cover• Removal of the input cover• Removal of the front cover• Removal of the side cover• Removal of the rear cover• Removal of the top cover• Open the sealed compartment• Close the sealed compartment• Installation of the top cover• Installation of the rear cover• Installation of the side cover• Installation of the front cover• Installation of the input coverR59770351 DP2K-20C 02/02/2010 87
