10. GUI – InstallationPicture frameProjector 1Picture frameProjector 2Width, Projector 2Width, Projector 1Overlap / Blend ZoneImage 10-28From the start (mask) position, you can blend zone size per edge (left, top, right, bottom). For each edge there will be a drop-offcurve for the blend zone.10.6.1 Blend & MaskAbout masking and blending width or heightOffset is used to clip the image on one or multiple sides (masking). This is used to hide parts of the picture that should not be shownon the screen. For example: if the source is a Windows PC, you can hide the menu bar using this method.The larger the Mask value, the more the image is masked (by black bar) at the corresponding side. E.g. Top mask of 100 will blankthe top 100 lines.Height or width is used to create a blending zone with a smooth brightness drop off. This is used to compensate for the doublebrightness in overlap areas. The value is the size of the blended area in pixels.How to adjust blend zones?1. In the main menu, select Installation → Blend and Mask → Blend – Mask.Image 10-29Blend and Mask menu, Blend – MaskThe Blend – Mask menu is displayed.Image 10-30Blend & Mask menu2. To enable blending, put the Enable switch to the right. The color of the switch becomes blue when enabled.3. To project masking lines on the screen, put the Show lines switch to the right. The color of the switch becomes blue whenenabled.104 R5906070 HDX 4K 07/11/2017
