Barco ImagePRO-SDI Installation Manual

Also see for ImagePRO: User guide

Contents

Barco ImagePRO-SDI Installation Manual Manual pdf 25 page image

Manual # 26-0302000-00 / Revision E ImagePRO – Multi Format Image Processor 11Video Input ConnectionsUniversal Input ConnectorsThe video input section on the ImagePRO TM rear panel provides three universal inputs. Each input can accept RGB,YUV, S-Video (Y/C), or composite (NTSC, PAL or SECAM) video signals. On ImagePRO™ and ImagePRO-SDI™Universal Inputs 1 & 2 are provided with HD-15 female connectors. On ImagePRO-HD™ Universal input 2 is providedwith an HD-15 connector. Universal input 1 is provided with a DVI-I connector, which can be converted to an HD-15via the DVI-I to HD-15 adaptor provided with the unit. Universal Input 3 is provided with BNC connectors on allmodels. All inputs are provided with a corresponding buffered loop-through. Connection pins for each video signal arespecified below.RGBHVPin 1 REDPin 2 GREENPin 3 BLUEPin 4Pin 5Pin 6 RED returnPin 7 GREEN returnPin 8 BLUE returnPin 9Pin 10 GNDPin 11Pin 12Pin 13 Hsync or CsyncPin 14 VsyncPin 151511156HD-15 Input Connector Pinout(as viewed from rear of unit)Format – RGB(Typical Devices: Computers)Format – YUV or Y Pr Pb (Betacam)(Typical Devices: DVD Player or Betacam Deck)Source to ImagePROTM Source to ImagePROTMR R/R-Y/C Y G/Y/COMPOSITEG G/Y/COMPOSITE Pr R/R-YB B/B-Y Pb B/B-YH H/C orV V Y G/Y/COMPOSITEU R/R-YFormat – S-Video (Y/C)(Typical Devices: S-Video DVD or VCR) V B/B-YSource to ImagePROTM Format – Composite (Typical Devices: NTSC/PAL DVD or VCR)Y G/Y/COMPOSITE Source to ImagePROTMC B/B-Y NTSC/PAL/SECAM G/Y/COMPOSITE*NOTE: Composite sync or separate Hsync and Vsync signals are accepted. Sync on Green is also supported.