3. Display installation3.6 First time starting upOverviewYou are now ready to start up your Coronis 5MP for the first time.1. Switch on your Coronis 5MP as described in "Standby switching", page 18.2. Turn on the computer connected to your display.If you have properly installed your display and display controller, the Windows start-up messages willappear once the boot procedure is finished.Your Coronis 5MP will be running in a basic video mode at a default refresh rate whenfirst time starting up. If you are using a Barco display controller, please consult the userguide delivered with it to install the drivers, software and documentation. When thisis done, your display will automatically detect the connected video input signal(s) andapply the correct video mode and refresh rate.16 B4100592 CORONIS 5MP 05/08/2014