Barco XDL-4K75 User Manual

Also see for XDL-4K30: Installation manual User manual

Barco XDL-4K75 User Manual Manual pdf 29 page image

3. Input & CommunicationActive 3D 4 column mode (4x1 layout)• 960 x 2160 @120 Hz• 960 x 2400 @120 Hz• 1024 x 2160 @120 HzPassivestereoStandard layout (1x1 layout) 3840 x 2160 @60 HzPassivestereo2 column mode (2x1 layout) 1920 x 2160 @60 Hz3.4 Communication connectionsCommunication Panel321 4 5 6 7 8 9 10 11 12 13Image 3-71 WIFI antenna for wireless IP (optional) 8 RS232 for serial communication2 12V 1A output 9 Sync Out 3D3 Firmware update / USB download log files 10 Sync In 3D4 10/100 base-T for external control over IP and Art-Net 11 Status lights5 DMX interface input 12 IR receive sensor6 DMX interface output 13 GSM antenna input (optional)7 XLR input for wired projector control12 V output12 V output, maximum 1 A, available when projector is not in stand by.DMX interfaceDMX is used as communication bus between different devices in the light technic. Each device has an input and an output, so thatthe bus can be looped between the different devices. According the standard a five wire cable with XLR connector is used.You can use the DMX input port to connect a DMX device (DMX console) to the projector. This way you can control the projectorfrom that DMX device (console). The DMX output port can be connected with the next device in the loop.Pin Description1 Earth2 Cold3 Hot4 Return - (or not used)5 Return + (or not used)DMXDMX-512 Lighting protocol over RS-485 interface. Carries information of 512 channels from a lighting controller tolighting devices. Standardized by USITT.RS232/RS422 inputThe communication interface of the XDL series projector supports RS232 and RS422 serial communication on two different typesof input connectors, a Sub-D connector and an USB connector acting as RS input when connected to an USB input of a PC.R5906151 XDL 17/04/2018 25