Bard FUSION-TEC HR Series Service Instructions Manual

Also see for FUSION-TEC HR Series: Service instructions

Contents

Bard FUSION-TEC HR Series Service Instructions Manual Manual pdf 6 page image

Manual 2100-670IPage 6 of 47FIGURE 2TEC-EYE Connection to Unit ControlModular Phone Connector forTEC-EYE Hand-Held Diagnostic ToolUSING THE TEC-EYETMTEC-EYE Hand-Held Service ToolThe TEC-EYE service tool is used to communicatewith the FUSION-TEC unit logic board. By connectingdirectly to the logic board inside the unit controlpanel, it is possible to perform diagnostics on the unit,adjust certain settings and verify unit and economizeroperation through a run test procedure. The TEC-EYEservice tool is required for unit setup and operation. TheTEC-EYE is supplied with the LV1000 controller but canalso be ordered separately (Bard P/N 8301-059).The menu driven interface provides users the abilityto scroll through two menu levels: Quick Menu andMain Menu. The menus permit the user to easily view,control and configure the unit.The controller is completely programmed at the factory;the default setpoints and their ranges are easily viewedand adjusted from the TEC-EYE display. The programand operating parameters are permanently stored onFLASH-MEMORY in case of power failure.The TEC-EYE connects to the wall-mount unit controlboard via an RJ11 modular phone connector as shownin Figure 2.When not being used, the TEC-EYE hand-helddiagnostic tool should be stored inside or near theLV1000 controller. Do not let the TEC-EYE leave theshelter site.ALARM KEYAllows viewing of active alarmsSilences audible alarmsResets active alarmsMENU KEYAllows entry to Main MenuESCAPE KEYReturns to previous menu levelCancels a changed entryUP KEYSteps to next screen in the display menuChanges (increases) the value of a modifiable fieldENTER KEYAccepts current value of a modifiable fieldAdvances cursorDOWN KEYSteps back to previous screen in the display menuChanges (decreases) the value of a modifiable fieldFIGURE 1TEC-EYE (Bard P/N 8301-059) Display and Interface (Status Screen Shown)ALARM KEYMENU KEYESCAPE KEY DOWN KEYUP KEYENTER KEYUser 2000Technician 1313Engineer 9254Use UP or DOWN keys and ENTER key to enter passwordTABLE 1LV1000/TEC-EYE Passwords (Defaults)