Barko Hydraulics 595ML Service Manual
                                                                                         | |
Contents
| 
page 47595 ML CRL (S)800-00177INSTALLING A NEW BATTERY1. Remove battery cables. Remember position of positive terminal and negative terminal so you can connect themagain correctly.2. Remove battery hold-down bar. Remove battery from compartment.3. Clean terminal posts of new battery and cable connections with wire brush.4. Install new battery in compartment. Install hold-down bar.5. Install and tighten battery cables. Connect negative cable last to prevent sparks.WARNINGDo not touch battery terminals with any metal. Sparks may occur, causing damageto battery and personal injury.ALTERNATOR DRIVE BELT ADJUSTMENT1. Loosen alternator adjusting bolt and mounting bolt. See Figure 1.2. Move alternator along adjustment bar to adjust tension of belt tohave 1/2" movement at 10 pounds of pressure at center of belt.3. Tighten alternator adjusting bolt and mounting bolt.After a new drive belt has been installed, it will be necessary to adjustit after 8 hours of machine operation.Adjusting Belt Tension1/2" of movementBELTADJUSTING BOLTADJUSTMENT BARALTERNATORFigure 1ALTERNATOR MAINTENANCECHECKING THE WIRING1. Turn the starter switch on.2. Connect a volt meter between the ground and: (See Figure 2.)a) the No. 1 alternator connector.b) the No. 2 alternator connector.c) the "BAT" connector.No. 1 terminal No. 2 terminal"BAT" terminalFigure 2AlternatorELECTRICAL SYSTEM MAINTENANCE CONTINUED... |
Related manuals for Barko Hydraulics 595ML
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine