Barko Hydraulics 930 Service Manual
Also see for 930: Operator's manual
                                                                                            | |
Contents
| 
page 44page 44page 44page 44page 44930-937 Mulcher (S)800-00258SAUER DRIVE PUMP CHARGE PRESSURESAUER DRIVE PUMP CHARGE PRESSURESAUER DRIVE PUMP CHARGE PRESSURESAUER DRIVE PUMP CHARGE PRESSURESAUER DRIVE PUMP CHARGE PRESSUREADJUSTMENT PROCEDUREADJUSTMENT PROCEDUREADJUSTMENT PROCEDUREADJUSTMENT PROCEDUREADJUSTMENT PROCEDURE1. Install pressure gauge on Forward Pressure Test Port.2. Start engine, run at full throttle.3. Loosen jamb nut.4. Adjust set screw. Charge pressure should be 450 PSI.5. Tighten jamb nut.6. Shut down engine.7. Remove pressure gauge.Note: Adjustments can be made to the set screw with engine off.To do this, check pressure, shut down the engine, adjust setscrew, restart engine and check pressure.Repeat until pressure is correct.SAUER DRIVE PUMP MAX PRESSURESAUER DRIVE PUMP MAX PRESSURESAUER DRIVE PUMP MAX PRESSURESAUER DRIVE PUMP MAX PRESSURESAUER DRIVE PUMP MAX PRESSUREADJUSTMENTADJUSTMENTADJUSTMENTADJUSTMENTADJUSTMENT PROCEDUREPROCEDUREPROCEDUREPROCEDUREPROCEDURE1. Install pressure gauge on Forward Pressure Test Port.(If you have the ability to view 2 pressures at once install thesecond gauge on the Reverse Pressure Test POrt now.)2. Disconnect drive pump spool centering hose.3. Cap and plug fittings. This allows pump to come on stroke withparking brake locked.4. Start engine, run just above an Idle.5. Engage parking brake.6. Shift transfer case into high range.7. Depress travel pedal to pressurize forward travel.WARNING Watch to make sure machine is not moving.WARNING Watch to make sure machine is not moving.WARNING Watch to make sure machine is not moving.WARNING Watch to make sure machine is not moving.WARNING Watch to make sure machine is not moving.8. Loosen jamb nut on Forward Pressure Adjustment.9. Slowly adjust Forward Pressure Adjustment screw until pressuregauge reads 5000 PSI.10. Tighten jamb nut.11. Shut down engine.12. Repeat steps for Reverse Pressure Adjustment.13. Remove pressure gauge.14. Connect spool centering hose.MULCHER MACHINE PRESSURE ADJUSTMENT PROCEDURE CONTINUED...SAUER DRIVE PUMPSAUER DRIVE PUMPSAUER DRIVE PUMPSAUER DRIVE PUMPSAUER DRIVE PUMPCharge PressureCharge PressureCharge PressureCharge PressureCharge PressureAdjustmentAdjustmentAdjustmentAdjustmentAdjustmentCentering HoseCentering HoseCentering HoseCentering HoseCentering HoseForward Pressure Test PortForward Pressure Test PortForward Pressure Test PortForward Pressure Test PortForward Pressure Test PortReverse Pressure Test PortReverse Pressure Test PortReverse Pressure Test PortReverse Pressure Test PortReverse Pressure Test PortForward Pressure AdjustmentForward Pressure AdjustmentForward Pressure AdjustmentForward Pressure AdjustmentForward Pressure AdjustmentReverse Pressure AdjustmentReverse Pressure AdjustmentReverse Pressure AdjustmentReverse Pressure AdjustmentReverse Pressure Adjustment |
Related manuals for Barko Hydraulics 930
manualsdatabase
Your AI-powered manual search engine