POWER REQUIREMENTS PAGE 22. BEFORE YOU BEGINThe Cv3 is an alarm reporting unit with an embedded HSPA transceiver.Included with this device are the following:• 16 pin terminal block for wiring sensor inputs• 16 pin terminal block for wiring relay outputs/radio/power• USB cable for PC programming• Programming software CD-ROM• SMA to TNC Antenna AdapterMay also include:• Carrier specific SIM Card• Dipole AntennaSystem RequirementsThe Cv3 is designed to operate on an HSPA network. In order to operateon a wireless network, you will require an account with a local wirelessprovider who will provide you with a Mobile Identification Number(MIN).Additionally, to program the Cv3 and the embedded transceiver, one of thefollowing is required:• Standard telephone set with DTMF keypad, or• Personal Computer with CD Drive and USB port runningWindows 2000/XP/7/VistaRegistering the Cellular TransceiverTo program the embedded cellular transceiver for use on the HSPAnetwork, you will need to obtain a phone number from your wirelessprovider. You will need to give your wireless provider the followinginformation:• SIM Card Number – included in the accessory bag• Installed “home” location – establishes the local calling region• A billing contact name and addressSIM Card (19 or 20 digits) ___________________________Phone Number (10 digits) ___________________________