Baroness HMC1560 Owner's Operating Manual

Baroness HMC1560 Owner's Operating Manual Manual pdf 12 page image

- 12 -8-2. Engine start . operation methodSet the throttle lever in the high-speed range.Check the instruments.[Key] [ON] (Energization)StartAfter the glow lamp goes out[Key] [S] (Start)Starting the engine before theglow lamp goes out will causethe fuse to blow out.Operation[Key] [ON] (Operation)OFFONSOFFONSOFFONSOFFONS[OFF][Start]Fuel gaugeFuel gauge[Energization][Operation]8-3. Engine stop methodReturn the throttle lever to the slow-speed position.Turn OFF the switch and remove the key.When storing the machine outdoors or for a longtime, be sure to put the rubber cap on.Park the machine in a horizontal state, turn off the engine, and check that all movablesections have stopped. Then put on the side brake and remove the key beforeleaving the machine. Never park the machine on a slope.8-4. Precautions to take when leaving the machineGlowlampChargelampOil pressurelampGlowlampChargelampOil pressurelampGlowlampChargelampOil pressurelamp- -10123421CAUTIONOrdinary bolt8 (80)18 (180)36 (360)60 (600)90 (900)M 6M 8M10M12M14Heat-treated bolt16 (160)36 (360)72 (720)120 (1200)Bolts are used for each part. After initial use of the machine, the bolts and nuts mayget loose. Tighten loose bolts and nuts.7. Tightening each part8. Engine starting sequenceOptimum tightening torque: N.m (kgf.cm)Before starting the engine, read the diesel engine operation manual tothoroughly understand the contents.Put on the side brake and set all driving units at the neutral position.Check that the covers are at correct positions and that there is no onearound the machine, and confirm safety before starting the engine.Do not start the engine in a room without an appropriate ventilator.Check that the knife clutch lever is disengaged before starting theengine.8-1. Engine startWARNING