−37−12-2 Cutting height adjustment● To avoid personal injury and damage by the cutting edges wear groves and handle thereel and bedknife with extreme care.1) Set the supplied cutting height gauge bar.c a ba. Small adjusting screw for the cutting height settingb. Small adjusting screw for the bed knife angle adjustmentc. Small adjusting screw for the Groomer adjustment(1) Set the "a" screw to desired cutting height.(2) Set the included angle of the bed knife with the screw of "b" by referring to the followingtable.Example: When the angle of the bed knife is 5 degrees and 15mm of cutting height, use12mm.2) Adjust the height of the rear roller.(1) As shown in the figure, apply the screw"a" and "b" on the cutting height gaugeto the bed knife, and adjust the rearroller. (Decide the position of the rearroller on the basis of the bed knifeangle.)(2) Loosen the cutting height adjusting nutfirst, and then adjust the rear rolleraccording to the cutting height gauge.(3) A t t h i s t i m e , t o a v o i d i n c o r r e c tadjustment, do not touch the FrontRoller on cutting height gauge surface.(4) Tighten the cutting height adjusting nutsecurely after completing the setting.Reel cutter Cutting heightadjusting nutRear rollerbaCutting height gaugeFront roller3) Adjust the height of the front roller.(1) Loosen the cutting height adjusting nutfor the front roller first, and lower thefront roller down to the cutting heightgauge.(2) Tighten the cutting height adjusting nutsecurely after completing the setting.4) Repeat steps 2) - (2), (3), (4) and 3) -(1), (2) on opposite end. Completeadjustment to one end before adjustingopposite end.Cutting height adjusting nutFront rollerCutting height gauge(A) (B) (θ)Bed knife angle (θ) Value of (B)7° Cutting height of (A) - 0.6mm6° Cutting height of (A) - 1.8mm5° Cutting height of (A) - 3.0mm4° Cutting height of (A) - 4.2mm3° Cutting height of (A) - 5.4mm2° Cutting height of (A) - 6.6mm1° Cutting height of (A) - 7.8mmSet the bed knife angle as the basis of 5 degrees, and change it depending on the*situation.