Installation of Lever DamperCautionSee "Tightening torques" (Page 3-5) .Note that the Baroness product warranty maynot apply to defects caused by incorrect orovertorque tightening etc.ImportantAfter fully tightening the bolt securing thepump idle lever and lever damper, loosen it1/2 turn, and then secure it with the lock nut.For installation, reverse the removingprocedure.Fuel tankRemoval of Fuel TankRemove the right tank cover. (See"Removal of Right Tank Cover" (Page7-39) .)Remove the meter panel. (See "Removal ofMeter Panel" (Page 7-40) .)Remove the drain plug from the fuel tank,and drain the fuel.31 2a1dupa-007Removal of Fuel Tank_0011 Hydraulic tank2 Drain plug3 Waste oil tray1.2.3.Follow the steps below to remove the fuelhose.With pliers, grab the hose clamp for thefuel hose and move it sideways, and thenremove the fuel hose.With a Phillips screwdriver, loosen thehose clamp for the return hose, and thenremove the return hose.from engineto filter12453a1dupa-008Removal of Fuel Tank_0021 Hose clamp2 Fuel hose A (engine)3 Fuel tank4 Hose clamp5 Fuel hose B (filter)Follow the steps below to remove eachdevice.Disconnect the wiring of the buzzer andtank unit.Remove the connector of the relay glowtimer.Remove the bolt, nut, and spring washer,and then remove the buzzer.4.[1][2]5.[1][2][3]LM2700Main bodyPage 7-46 Removal and installation of each section