Baroness LM283 Owner's Operating Manual

Also see for LM281: Owner's operating manual

Contents

Baroness LM283 Owner's Operating Manual Manual pdf 38 page image

Principal tightening torquesTightening Torque by ModelLM283Tighten the following bolts and nuts at the torque specified in the table.For thread locking adhesive, apply a middle strength thread locker (ThreeBond 1322 anaerobicadhesives).Location Code Part nameTightening torque ThreadlockingadhesiveN-m kgf-cm lb-inFront wheel Motor K0013120602 Bolt, 11T, heat-treatedM12-60104 –1341,060.49 –1,366.40920.50 –1,186.03 －Wheel mountingbase K0160000492 24 special nut P1.5 180 –2001,835.46 –2,039.401,593.18 –1,770.20 ○Wheel K0011120302 Bolt, 11T, heat-treatedM12-30P1.5 67 – 85 683.20 –866.75593.02 –752.34 －Rear wheel Wheel mountingbase K0138240002 24 slotted nut high P1.5 180 –2001,835.46 –2,039.401,593.18 –1,770.20 －Wheel K0011120302 Bolt, 11T, heat-treatedM12-30P1.5 67 – 85 683.20 –866.75593.02 –752.34 －Tie rod K1610000020 Tie rod end right ass'y 45 458.87 398.30 －K1611000020 Tie rod end left ass'y 45 458.87 398.30 －Lever damper K0144080002 8U nut — — — ○EngineK0017100252 Bolt, heat-treated, small,10-25 P1.2545 – 57 458.87 –581.23398.30 –504.51 －Since it may be difficult to tighten bolts andnuts in the upper front left area of the engine,the strength category should be 4.8 torque.(See "Standard tightening torques" (Page4-14) .)K4040000150 Nut for attaching anti-vibration rubber 28 – 38 285.57 –387.49247.83 –336.34 ○CouplingK0024100351 Bolt, 12T, w/hexagon hole,M10-35 60 – 70 611.82 –713.79531.06 –619.57 －K0013100352 Bolt, 11T, heat-treatedM10-35 45 – 76 458.87 –774.97398.30 –672.68 －K0010100202 Bolt, 11T, heat-treatedM10-20 45 – 76 458.87 –774.97398.30 –672.68 ○K0010080202 Bolt, 11T, heat-treatedM8-20 23 – 38 234.53 –387.49203.57 –336.34 ○Bed knife (bottomblade) K0071000092 Screw, heat-treatedflathead M10-20 29 – 38 295.71 –387.49256.68 –336.34 －Arm frameRoll bar K0013120302 Bolt, 11T, heat-treatedM12-45 52 – 67 530.24 –683.20460.25 –593.02 －LM283Handling InstructionsPage 4-16 Tightening torques