Barrus Shire 65 Original Instruction

Contents

Barrus Shire 65 Original Instruction Manual pdf 50 page image

RDG603A31- Issue 4 Page 50 of 8811. Belt ReplacementWARNING:SEVERE HAZARD! KEEP HANDS AND OTHER BODY PARTS AWAY FROMMOVING/ROTATING PARTS. WEAR TIGHT FITTING CLOTHING AND KEEP YOURHAIR SHORT OR TIE BACK. REMOVE ALL JEWELLERY BEFORE COMMENCINGWORK. CHECK BEFORE STARTING THE ENGINE THAT ANY TOOLS OR RAGSUSED DURING MAINTENANCE HAVE BEEN REMOVED FROM THE AREA. Ensure the ignition key is removed before replacing any belts. Turn the battery master switch to the off position before replacing any belts. Ensure that you have the correct replacement belts before starting this procedure.Some engines may have been fitted with non-standard optional alternators which maynot use the belt sizes listed. Make a note of these belt sizes upon delivery. Loosen the top adjuster bolts and the lower mounting pivot nut and bolt. Push the alternator towards the engine to loosen the belt. Remove the belt. Hold the belt in position over the top alternator pulley. Rotate the engine if required byhand, to guide the new belt into the “vee”. Re-tension the belt as above.12. Control Panel MaintenanceWARNING:REMOVE THE IGNITION KEY BEFORE WORKING IN ENGINE COMPARTMENT.TURN BATTERY ISOLATION SWITCHES OFF. To replace an illumination bulb: Release the panel from its mounting. The bulbsare accessible from the rear of the panel. Remove the wires, unscrew the nut and pullout the bulb housing from the panel. Remove the bulb and replace. Refit bulb housing,screw the nut back up and refit the wires. To replace any gauge: Release the panel from its mounting. The gauges areaccessible from the rear of the panel. Unplug the wire connectors, unscrew and pullthe gauge out of the panel. Replace the gauge and refit. Reattach the wiringconnectors.