Barska NVX200 Manual
       | |
w w w . b a r s k a . c o m w w w . b a r s k a . c o m10 11NVX200 NVX200Menu SettingsThis is to set up parameters for the binocular if you wish to change defaultsettings. Press Mode multiple times until the Menu shows up. Press IR to godown the menu, or Zoom to go up the menu. Press to enter. Once the desiredsetting is selected, press to save it. Press Mode to exit back to the photomode.MenuFormat SD To delete all the files in SD cardPower Save To set up auto power offDate To set up the dateTime To set up the timeFlicker 50Hz (Default setting for EU)LCD Backlight 60Hz (Default setting for U.S. and Japan)Date/Time Tag To select the brightness level of the LCD screenVersion To show date and time on the photosFormat SDYes To delete all the files in SD cardNo Not to delete all the files in SD cardPower SaveOff No auto power off (Default Setting)5 min Auto power off in 5 mins without actions10 min Auto power off in 10 mins without actions15 min Auto power off in 15 mins without actions30 min Auto power off in 30 mins without actionsDateYY/ MM/ DD Press to enterPress Zoom and IR to go left and right, up anddown, Press to saved settingsTimehr / min / sec Press to enterPress Zoom and IR to go left and right, up anddownPress to saved settingsFlicker50Hz Default setting for EU60Hz Default setting for U.S. and JapanLCD BacklightDefault setting is 10Slide Bar in 16 levels (0-15) of brightnessDate / Time TagOff Default setting is offOnVersionVersion of the Firmware for reference onlyTrouble ShootingBinocular PowerOffIf the binocular fails to activate, check for defective,missing or improperly-installed batteries. Replace or installbatteries correctly. Please make sure to use Alkalinebatteries.Poor ImageIf you wear glasses, please keep them on while using thebinocular.If at day, make sure the protection lid is on. If at night,make sure the protection lid is off.Adjust the focus by slowing turning the Focus Wheel at thefront bottom of the binocular. Make sure it is focused.Why is “Pleaseinsert SD Card”message showingon the screenwhile the SDcard has beeninserted?Please turn off the power, insert the card, and checkagain. The SD card needs to be inserted when the poweris off.If the issue persists, please check the SD cardcompatibility. In some cases, SD card holders that holdmicro SD cards may have minor differences than regularSD cards, causing the failure for the card to be read. Inthis case, try inserting another SD card. |
Related manuals for Barska NVX200
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine