Bartec POLARIS Panel PC 19.1" User Manual

Bartec POLARIS Panel PC 19.1" User Manual Manual pdf 22 page image

User manualPOLARIS Panel PC 19.1'' and Panel PC 15''Version 2.00 Page 22 of 46E_BMS790_POLARIS_PanelPC_19+15_Rev1.doc • User manual for POLARIS Panel PC 19.1" and 15" • Revision 1 / Status: January, 3 rd , 2006 • Technical data subject to change5. Notes on the installation of POLARIS Panel PC5.1 Safety instructionsFor electrical appliances, the appropriate regulations for setting-up and operation have to be observed(e.g. directive 1999/92/EC, directive 94/9EC, BetrSichV and national regulations/acts, IEC/EN 60 079-14 and VDE 0100).The operator of an electrical appliance in an area where there is an explosion hazard has to maintain the resources in aproper condition, operate them correctly, monitor them and carry out maintenance and repair work (BetrSichV and nationalregulations/acts and EN 60 079-14).Where the IP rating is concerned, only original replacement parts may be used (e.g. lid seal).The unit may be opened only in the manufacturer's works!The unit is factory sealed! Do not open!5.1.1 Safety-relevant noticeInside areas of explosive atmospheres any electrostatic charging mechanism on the surface of the indicating terminals haveto be excluded if they are stronger than manual rubbing (e.g. cleaning by hand).5.2 MaintenanceFor the maintenance, servicing and checking of associated resources, adhere to the valid regulations in accordance withdirective 1999/92/EC, IEC 60079-19 and EN60079-17 !Installation / dismantling, servicing and maintenance work may only be carried out by trained specialists. The generalstatutory regulations and other binding directives on workplace safety, accident prevention and environmental protectionmust be adhered to.Observe the national disposal of waste regulations when disposing of this equipment at the end of its useful life.5.2.1 ServicingIf operated correctly, in accordance with the installation instructions and environmental conditions, no regular servicing isnecessary.5.2.2 InspectionIn accordance with IEC 60079-19 and EN 60079-17, the site operator has an obligation to ensure that any electricalappliance installed within, an area containing gases and dust, which could be potentially explosive, is correctly installed bytrained personnel and that the installation is regularly inspected and correctly maintained to ensure the safety of theoperatives in the area.