RIDE-ON FAMILYOWNER’S MANUAL23OIPB – B19007TROWEL ARM ADJUSTMENT FIXTUREPart #20801Unit 36” (TS88, BXR836, TS78,All Titans)1) 10411 – Trowel arm2) 10817 – Lift lever3) 10808 – Jam nut4) 10809 – Set screw5) 10824 – Block top6) 10507 – Bolt7) 10816 – Jam nut8) 10815 – Carriage bolt9) 10832 – Adjustment bar10) 10507 – BoltPart #20801Unit 46” (TS96)1) 14161 – Trowel arm2) 14163 – Lift lever3) 10808 – Jam nut4) 10809 – Set screw5) 10824 – Block top6) 10507 – Bolt7) 10905 – Washer8) 10807 – Carriage bolt9) 10832 – Adjustment bar10) 10507 – BoltThe trowel arm adjustment fixture (20801) is reversible. By rotating the arm clampingfixture and the ring bolt, both left hand and right hand trowel arms may be adjusted. Beforeattempting adjustment, determine whether the trowel arm is right handed or left handed. Whenadjusting left hand trowel arms use the side of the fixture marked “L”. When adjusting right handtrowels arms use the opposite side.ADJUSTMENT PROCEDURE1. Remove all trowel arm assemblies (1 & 2 arm and attached lift lever) from spider plate.2. Remove lift lever (2) from trowel arm (1) by first loosening jam nut (3) then square headscrew (4). If upon inspection (method left to discretion of serviceman) any trowel arm (1)is found to be in a bent condition, it must either be brought back to its original straightcondition (method left to the serviceman’s discretion) or replaced with new part.3. Replace lift levers (2) on new or straightened arms (1) by reversing procedure describedabove.4. Place trowel arm assembly (1 and 2) in fixture (5) with lift lever (2) butting up againstfixture. Secure in place with bolts (6).5. Loosen locknut (7) and screw carriage bolt (8) down to full depth allowable. This willprovide for ample clearance to swing adjustment bar (9) over head of carriage bolt.Adjustment bar (9) is stamped for appropriate size of machine. Swing appropriate sidedirectly over carriage bolt (8) and secure in place with bolt (10).NOTE: It is important that when tightening square head setscrew (4), it seats itselfsecurely into dimple machined arm.Discount-Equipment.com