Bartell P-2400 Owner's Manual
                    | |
Bartell Morrison Inc.375 Annagem Blvd., Mississauga, ON, CanadaToll Free - 866-501-1683Bartell Morrison (USA) LLC12 Industrial Dr., Mississauga, NJ, USAToll Free - 888-999-15705Safety Hazardalert:Alerts the reader topersonal injury hazardsand other important,potentially life-savinginformation.daNGer:Beware of a hazardoussituation that WILL re-sult in serious personalinjury or death.WarNING:Beware of a hazardoussituation that COULDresult in serious per-sonalinjury or even death.CaUtION:Beware of a hazardoussituation that couldresult in minor personalinjury or equipmentdamage.PRODUCT SAFETY AND HAZARD ALERT SYSTEMThis Operating Manual presents Product Safety and Hazard Alert Information in accordance withAmerican National Standards Institute and International Organization for Standardization rec-ommendations as laid out in ANSI Z535 and ISO 3864. The callouts of DANGER, WARNING,CAUTION, and NOTE must be followed to reduce or avoid the potential for personal injury,equipment damage, or service-related equipment failures.Only persons who have received training are permitted to operate or repair the grinder.1.Use personal safety equipment such as steel toe shoes, safety glasses, gloves and ear2.plugs.Do not use grinder in area where there is a risk of explosion or fire.3.Do not start the machine with heads off the ground.4.Make sure the splash guard is on before starting machine.5.Before you start grinding, check the floor for bolts, large holes and uneven joints. Hitting6.these things can damage machine, tools, and cause personal injury.Make sure all power supply is connected with the right voltage.7.Use only cold water in water tank. Do not use chemicals in water tank.8.When filling water tank, to avoid electrical hazards and injury, do not spill water onto the9.machine motor and electrical box.Switch off the machine power before changing grinding tools.10.Disconnect power supply before working on or repairing machine.11.Be very careful with rolling machine on any sloping floors or ramps. The machine can roll12.very quickly. Two people may be needed to handle and control the machine.Use caution when removing the grinding tools after finished grinding. Tools can be very13.hot. Use gloves to remove the plates.When grinding glues, epoxy paints, or coatings, leaving the machine down on floor could14.cause the head to stick to the floor. Always tip back machine as soon as the head comes toa complete stop.Always store machine in a dry place.15.Only use Innovatech recommended tooling.16. |
manualsdatabase
Your AI-powered manual search engine