BaseStation 3200 Quick Start GuidePage 96. Press the Next button to move to the Soak Time field. If you are using soak cycles for thiszone, the soak time defines the duration of each soaking cycle interspersed with wateringtimes.7. Press the Next button to move to the Enabled field. Press the + or – button to display YES inthe field.8. Press the Next button to move to the Use ET Deficit Water Times field. Press the + or –button to toggle the value in the field between YES and NO.IMPORTANT NOTE! You can enable ET in the BaseStation 3200 controller, but you must alsohave a weather-station connected to BaseManager and assigned to the controller inBaseManager. Selecting this option in the controller has no effect unless you complete theseadditional steps in BaseManager. Also be aware that when you enable a zone to useWeatherAccess in BaseManager, the Use ET Deficit Water Times option is automaticallyselected in the controller.9. Verify that the number displayed in the Program field in the upper-left corner of the screenmatches the program in which you want to set up the timed zone. If you want to set up the timed zone in a different program, press the Next button tomove to the Program field, and then press the + or – button to change the programnumber. To remove the zone from the current program, press the Previous button to return tothe Water Time field, and then press the – button to remove the watering time in thefield.10. After you have configured the settings for the current zone, perform one of the followingoptions: To configure another zone, press the Enter button until the number of the zone that youwant to configure displays in the Zone field at the top of the screen. Repeat steps 3 – 10. When you have finished making changes, turn the dial to the RUN position.STEP 5 – Set Up ProgramsSetting Up the Start Times for a Program1. Turn the dial to the Programs position.2. The Program Start Times Setup option should be highlighted. If it is not highlighted, press theNext button to highlight it.3. Press the Enter button. The Start Times screendisplays.4. Verify that the number displayed in theProgram field matches the program that youwant to set start times for. If you want toselect a different program, press the + or –button to change the program number.