Batavia BT-PS001 Operating Instructions Manual

Contents

Batavia BT-PS001 Operating Instructions Manual Manual pdf 33 page image

33EN1. When installing the miter limit stop on theguide rail first set the desired angle andslide the miter limit stop into the groove ofthe guide rail.2. Tighten the front clamping screw to fix theangle setting.3. Place the miter limit stop at the straight sideof the work piece.4. Tighten the second clamping screw to fixthe miter limit stop tightly on the guide rail.5. Slide the miter limit stop into the groove ofthe guide rail and set the angle by means ofthe notches from 0° to 45° when installingthe miter limit stop on the guide rail.Note: The pre-punched notches match thecurved angle scale.6. Tighten the second clamping screw to fixthe miter limit stop tightly on the guide rail.PARALLEL LIMIT STOP AND/OR TABLEEXPANSION (OPTIONAL)For cut-off widths up to 180 mm a parallel limitstop can be used. The parallel limit stop canalso be used as table expansion.1. Slide the parallel limit stop into therespective guides at the front and rear ofthe base plate.2. Measure the desired distance and fix theparallel limit stop with the clamping screws(9).SAW BLADESCompatible saw blades are necessary for theplunge saw to cut different materials fast andclean.Saw blades with few teeth (approx. 12 – 18teeth) are suitable for longitudinal cuts.For cross cuts saw blades with at least 32teeth are suitable; better are saw blades with48 teeth.For cutting other materials such as aluminumspecial saw blades are necessary.CLEANING AND MAINTENANCEDisconnect from mains power before carryingout any maintenance work on the plunge saw!All maintenance and repair work involvingopening the motor casing must be carried out7061274 Ma # 1406-17.indd 33 17-06-14 13:29